|
Labels
|
Show labels | Turns labelling of isolines on or off |
Distance along line | The distance between labelling points along each isoline (staring
at the middle of each polyline of each isoline) The initial value of the distance value is calculated based on the median extent of the component modelled (1/3 of it). |
Proximity | The minimum distance between any two labelling points. |
Font size [pts] | Size of letters used for labels. The actual size scales with the height of the 3d view. |
Decimal digits | Number of decimal digits after decimal comma to show on isoline labels. |
Remark: In general it is advisable to keep the distance along line at 1/3 of the component's extent. The proximity is commonly changed together with the font size. Generally the Proximity is always smaller then Distance along line.
Remark: Visibility of each separate label is checked against all opaque surfaces and objects within the view. Transparent surfaces and do not obscure labels.
Remark: Labels of isolines shown with active isoline option "Bold n-th" are shown on emphasized isolines only.
The tricky algorithm positioning the labels can be described as follows:
Value labels of the colorbar are placed at one side of the coloured bar.
Show labels | Turns labelling of
colorbar on or off |
# Intervals | Defines the number of intervals at which the colorbar shall be labelled. |
Decimal digits | Number of decimal digits after decimal comma to show on colorbar labels.. |
Remark: When Results3D is showing a periodic evaluation at some time point, the title of the colour bar will
display that value.
See also: Isolines / Isotherms (control panel), Slice X,Y,Z (control panel), Results 3D window, Colorbar (control panel)
|